Content Preview
TB095 Rev1 Installing MPG Handwheel into M39 Pendant
Tools Required
1 #2 Phillips Screwdriver
Procedure
This document outlines the procedure for installing the MPG handwheel into the M39 pendant
Be sure to power down the control before beginning the following procedure
1 Remove the aluminum blank from the M39 pendant by removing the 2 Phillips head screws from the
bottom edge and lift the bottom edge out as pictured in figure 1
2 Plug the cable located in the M39 pendant into the receptacle located on the back of the MPG Module as
pictured in figure 2 Also remove one of the 4 screws holding the circuit board to the module place the
terminal loop over the screw and secure the shield wire and screw back to the circuit board
3 Insert the MPG module into the M39 pendant top edge first and press it down into the pendant body as
pictured in figure 3 Make sure all wiring is running to the side of the MPG encoder not underneath as this may
pinch wires
4 Re install the 2 Phillips head screws into the base of the MPG module tighten till snug Power your control
back up and you are finished
Document History
Rev1 Created on 2000 05 02