Content Preview
TB073 Rev1 M39 E Stop Protection Bracket Retrofit
Overview
This document describes the proper installation of the E stop protection bracket on the M 39 pendant
This bracket is designed to prevent damage to the M 39 pendant E stop
Procedure
1 Remove the two Allen head screws and the magnet from the backside of the M 39 pendant
2 Place the bracket on the back of the pendant as indicated in the illustration below and install the provided
Phillips head screws as indicated Be sure not to over torque these screws or the inserts could strip out of the
plastic housing
Â
Document History
Rev1 Created on 1999 07 19