Content Preview
TB211 Rev1 Installing MicroATX PS with bracket into an existing M400
Uniconsole
Purpose
This document describes how to mount a microATX power supply and its bracket outside the PC sheet
metal and onto the top side of the console wrap This gets the power supply away from the motherboard
which prevents accidental unseating of the RAM due to the conditions seen by the transport carrier and
helps cool the ambient air temperature that is seen by the processor since the heat from the power supply
is now away from the processor and there is no longer a cover plate on the front panel
Required Materials
รฏยท MicroATX Power Supply with Sheet Metal Bracket Installed
รฏยท 4x 6/32 x 1/4" Black Oxide Screws
รฏยท Drill with No 11 Drill Bit
Instructions
1 Use the template on Figure 1 to drill out the holes on top of the console wrap
2 Use the screws mount the microATX power supply with bracket to the console wrap
3 Connect the appropriate cables to the motherboard and additional items e g LCD controller board
console fan etc
4 Install the CPU10 bracket as shown in Illustration 2 Depending on the motherboard the CPU10 B may
not slide using the original guide You can use the included rubber feet or tie strain to hold the CPU10 B
in place
Document History
Rev1 Created on 2014 04 08 by #270
Figure 1 MicroATX Power Supply Template
Figure 2 CPU10 B Holder