Content Preview
TB181 Rev1 Adding a 28 Pin MPG to a Rev B Jog Pendant
1 Remove the four 6 32 by 3/8Â screws holding the jog panel onto the jog pendant
2 Pull the jog panel away from the jog pendant slowly to avoid damaging jog pendant cable
3 Remove the jog pendant cable noting which connector it was attached to
4 Using a flat screwdriver remove the e stop connector from the back of the e stop switch
5 Set the jog panel aside
6 Using a Philips screwdriver remove and discard the right side handle and clips
7 Screw a 10 32 by 1/2Â screw part way into the PEM nut that held the handle clips Tap both PEM nuts out with a
hammer
8 Using the MPG hook as a template center the hook mounting holes over the handle mounting hole and center punch
the mounting holes for the hook and the spring clip
9 Drill the mounting holes that were center punched in the last step with a number 25 drill
10 Mount the MPG hook to the top of the jog pendant with two 6 32 by 3/8Â black screws with nylon nuts
11 Mount the spring clip to the bottom of the jog pendant with two 6 32 by 3/8Â black screws with nylon nuts
12 Cut out the MPG connector template
13 Tape the MPG connector template to the bottom right hand side of the jog pendant
14 Center punch all five holes
15 Drill the four mounting holes with a number 25 drill
16 Punch the connector hole with a 1 1/8Â punch
17 Mount the MPG connector from the inside of the jog pendant using four 6 32 by 3/8Â black screws with nylon nuts
18 Make sure jumpers in middle of jog panel are set to 3rd party MPG
19 Reconnect e stop connector to e stop switch
20 Reconnect jog panel cable to jog panel
21 Connect MPG cable to 3rd party MPG connector
25 Mount the jog panel to jog pendant reusing the 6 32 by 3/8Â screws
Document History
Rev1 Created on 2006 08 17 by #000